Synology DS1813+ Guide d'installation télécharger pdf (Page 11)

11 Chapter 2: Hardware Setup

5 Reconnect the cables you removed in step 1, and then press and hold the power button to turn on your

DiskStation.

To make sure DiskStation recognizes the new memory capacity:

1 Install DiskStation Manager (DSM). (See the next chapter for more information.)

2 Log in to DSM as admin or a user belonging to the administrators group.

3 Check Total Physical Memory in Main Menu > System Information.

If your DiskStation does not recognize the memory or does not start up successfully, confirm that the memory is

installed correctly.

To remove the RAM Module:

1 Follow step 1 and 2 of the "To install the RAM module" section to shut down your DiskStation, disconnect the

cables, and then remove the top case.

2 Push the levers on the sides of the memory module in an outward direction to release the module from the

memory card slot.

3 Hold the memory module by its notches and remove it from the slot.

4 Replace the top case. Replace and tighten the screws you removed in step 2.

5 Reconnect the cables you removed in step 1, and then press and hold the power button to turn on your

DiskStation.

DS1813+

4096 MB

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Pas de commentaire

Synology DS1813+ Guide d'installation Page 11