Synology DiskStation DS1815+ Guide d'installation télécharger pdf (Page 11)

Chapter 2: Hardware Setup

To make sure DiskStation recognizes the new memory capacity:

Install DiskStation Manager (DSM). (See the next chapter for more information.)

admin

or a user belonging to the

administrators

group.

Check

Total Physical Memory

Control Panel

Info Center

If your DiskStation does not recognize the memory or does not start up successfully, conrm that the memory is

installed correctly.

To remove the RAM Module:

Follow step 1 and 2 of the "To install the RAM module" section to shut down your DiskStation, disconnect the

cables, and then remove the top case.

Push the levers on the sides of the memory module in an outward direction to release the module from the

memory card slot.

Hold the memory module by its notches and remove it from the slot.

Replace the top case. Replace and tighten the screws you removed in step 2.

Reconnect the cables you removed in step 1, and then press and hold the power button to turn on your

DiskStation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Pas de commentaire

Synology DiskStation DS1815+ Guide d'installation Page 11