Synology DS414j Guide d'installation

Synology DiskStation DS414j Quick Installation Guide Synology_QIG_DS414j_20140211

10 Chapter 3 Chapter 3: Install DSM on DiskStation After hardware setup is finished, please install DiskStation Manager (DSM) – a browser-base

11 Chapter 3: Install DSM on DiskStation Learn More Congratulations! Your DiskStation is set up now. Refer to the User’s Guide in the instal

12 Appendix A Appendix A: Specifications Item DS414j Internal Drives 3.5" or 2.5" SATA (II) x 4 Max. Capacity 16 TB (4 x 4 TB har

13 Appendix B Appendix B: LED Indicator Table LED Indicator Color Status Description STATUS Green Static Volume normal Orange Static Ava

SYNOLOGY, INC. END USER LICENSE AGREEMENT IMPORTANT–READ CAREFULLY: THIS END USER LICENSE AGREEMENT ("EULA") IS A LEGAL AGREEMENT BETWEE

INABILITY TO USE THE SOFTWARE OR OTHERWISE UNDER OR IN CONNECTION WITH THIS EULA OR THE SOFTWARE, WHETHER BASED ON CONTRACT, TORT (INCLUDING NEGLIGE

SYNOLOGY, INC. LIMITED PRODUCT WARRANTY THIS LIMITED WARRANTY ("WARRANTY") APPLIES TO THE PRODUCTS (AS DEFINED BELOW) OF SYNOLOGY, INC. AN

the expiration of the applicable Warranty Period, support for Products may be available from Synology upon written request. 2.7 Exclusions. The f

single arbitrator, and will be limited solely to the dispute between Customer and Synology. The arbitration, or any portion of it, will not be cons

2 Table of Contents Chapter 1: Before You Start Package Contents ...

3 Chapter 1 Chapter 1: Before You Start Thank you for purchasing this Synology product! Before setting up your new DiskStation, please check t

4 Chapter 1: Before You Start Synology DiskStation at a Glance No. Item Location Description 1) Disk Indicator Front Panel Displays the

5 Chapter 1: Before You Start Safety Instructions Keep away from direct sunlight and from chemicals. Make sure the environment does not exp

6 Chapter 2 Chapter 2: Hardware Setup Tools and Parts for Drive Installation  A screwdriver  At least one 3.5” or 2.5” SATA drive (please

7 Chapter 2: Hardware Setup 3 Load drives in the drive trays.  For 3.5” drives: Place the drive in the drive tray. Then tighten the screw

8 Chapter 2: Hardware Setup 6 Drives are numbered as shown below.  For 3.5” drives (only): Secure the drive trays with the screws (for s

9 Chapter 2: Hardware Setup 8 Close the back cover. Replace and tighten the 4 screws you removed in step 1. Note: If you want to create a