Synology RS814 Guide d'installation télécharger pdf (Page 7)

7 Chapter 2: Hardware Setup

3 Insert the loaded hard drive tray into the empty hard drive bay.

Important: Make sure the tray is pushed in all the way. Otherwise, the hard disk might not be able to function

properly.

4 Press the handle in flush with the front panel to hold the hard drive tray in place.

5 Insert the hard drive tray key into the hard drive tray lock, turn the key clockwise to lock the handle of the hard

drive tray, and then remove the key.

6 Repeat the steps above to assemble all hard disks you have prepared.

7 Fix the two rack mount kits on both sides with the nuts provided.

8 The disks' positions are numbered as shown below.

Note: If you want to set up a RAID set, it is recommended that all installed hard disks are of the same size to make

the best use of hard disk capacity.

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Pas de commentaire

Synology RS814 Guide d'installation Page 7