Synology DS2415+ Guide d'installation télécharger pdf (Page 13)

Chapter 2: Hardware Setup

Replace System Fan

Your DiskStation will play beep sounds if either of the system fans is not working. Follow the steps below to

replace the malfunctioning fan module with a good one.

To replace the system fan module:

Shut down your DiskStation. Disconnect all cables connected to your DiskStation to prevent any possible

damages.

Pull the 6 push pins that secure the fan module.

To remove the malfunctioning fan module, you simply need to pull it out from your DiskStation.

Install the new fan module:

Install the new module with the power connector at the bottom, so that it can be properly put onto the

chassis.

Make sure all six push pins are pulled outwards before the module is attached, and then press the push pins

back into place to secure the fan module.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Synology DS2415+ Guide d'installation Page 13